Jump to content

turn Signals wont flash


Recommended Posts

All the bulbs must be exactly the same wattage and the flasher must be matched to those bulbs..or the bulbs matched to the wattage of the flasher.Make sure all the connections to the indicators are clean and a good fit...check the earths and make sure their all clean and attached solidly to their respective points ,,,thats all earths not just the flasher ones..Also try starting the bike..Sometimes they won't flash if the batteries a bit dodgy.The xtra power to it sometimes kicks them off.

Link to comment
Share on other sites

All the bulbs must be exactly the same wattage and the flasher must be matched to those bulbs..or the bulbs matched to the wattage of the flasher.Make sure all the connections to the indicators are clean and a good fit...check the earths and make sure their all clean ,,,thats all earths not just the flasher ones..Also try starting the bike..Sometimes they won't flash if the batteries a bit dodgy.The xtra power to it sometimes kicks them off.

You bring up some key points. The wattage's must all match. All grounds/earths must be clean. Any difference in resistance will cause some funky stuff to happen.

Link to comment
Share on other sites

thats also a notice to let you know if a bulbs out maybe? alot like a car when ones out the blinker will flash funny and ill bet this may do that also, not certain but sounds like it does.

Where in CA are you? Welcome to TT

Link to comment
Share on other sites

  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

×
×
  • Create New...