Another Eddy Question - Sticky Pumper and the Blue O-ring


No replies to this topic
  • irondawg

Posted February 25, 2008 - 03:02 PM

#1

I've got the dreaded hanging idle that many also here have with the Eldebrock carb. After checking the cables, and carb for gumming and finding nothing I took the pumper mechanism out and noticed that it is hanging badly and not letting the slide down completely unless I blip the throttle. What I mean is when I push the mechanism down, it stays down and take a bit of force to pull back up...not much but more than I think it should.

I tried lubing the blue o-ring with no luck. My next thought was that the o-ring has swollen. What I'd like to know is how much friction should the pumper mechanism have. Should it slide up and down with little effort? Should it pop back up using only the little spring in the mechanism.





Related Content

Forums
Photo

Fell Off Trailer by usafxr


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  43 replies
Forums
Photo

Wiseco 101MM Spark Knock Low Engine Temps by imandrewparks


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 9 replies
Wiki
Want to add a kickstart to your XR650L?  Here's how - last post by clc3251

Want to add a kickstart to your XR650L? Here's how


Articles
  • 1 reply
Forums
Photo

DirttyPig 2005 Xr650l Prroject! by braapmebb1moretime


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 22 replies
Forums
Photo
Washington

Cle Elum Sunday 5/29: Looking for dual sport tips by TigerTanker


Dirt Bike   Dirt Bike Regional Discussion   Northwest
  • Hot  32 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.