Replacement crank shaft different than original one????

1 reply to this topic
  • chrispy1202

Posted February 22, 2008 - 04:44 AM


I ordered a new crank shaft from the TT store (part #5TJ-11400-00-00), and put the engine back together to the point where the starter gear/clutch/rotor go back on. This end of the crank seems to be different, because the shaft is way smaller than the original rotor mount hole.:smirk: The rotor is supposed to be a squeeze on deal. Do i need a different rotor now??? Any help will be appreciated. I wll call the TT store this afternoon. Anyone else have this issue? I was looking forward to getting out for a ride this weekend.... this sucks!:)

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed

Posted February 22, 2008 - 06:55 AM


Hmm... Sounds like you have an '03 crank and a later motor? Crank size was increased in '04.


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.