Works connection skid plate fit

4 replies to this topic
  • wes782

Posted February 13, 2008 - 08:33 PM


So i got a works connection skid plate for my 07 and it is a pain in the ass to get lined up!! anyone else have any problems getting it lined up, any tricks? any help would be appreciated thanks!

  • Dveitch8

Posted February 13, 2008 - 08:49 PM


try getting the back bolt started first then get a small screwdriver through the skidplate into one of the front mounts and pry it forward to get one of the front started after this is should be easy. The first time was a pain but for some reason after that it goes on and off real easy and fits really tight. Good luck!:applause:

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • hi everybody

Posted February 13, 2008 - 09:44 PM


I had to "unbend" mine a bit. as if the curve to match the frame was a little bit over done..but after that first fit, it comes off and on pretty good...just dont crossthread the screws!

  • jcolborn48

Posted February 13, 2008 - 10:56 PM


Yep, I had the same problem, start the back screw, keep it loose and then get the front started, it'll fit OK


Posted February 14, 2008 - 06:12 AM


Next time get one of these!!!


Related Content



Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • Hot  30 replies

Yamaha YZ450F 2017 by Chris.GVS

Yamaha YZ450F 2017
  • * * * * *
  • 1 review
  • Last review by Tommyk_55
  • On January 15, 2017

Snake pit oct 30th by The Anvil

Dirt Bike   Dirt Bike Regional Discussion   California
  • Hot  293 replies
WR Camshaft Swap Info - last post by jamesm113

WR Camshaft Swap Info

  • 0 replies

BIGBORE FOR YZ450F 2006? by Taattie94

Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • 5 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.