Quick clutch question ’00 426


4 replies to this topic
  • Nizzle

Posted February 01, 2008 - 10:20 PM

#1

Ok its time for a new clutch so I ordered an ebc dirtracer clutch kit because I’m poor and when I got I noticed the clutch plates look a little different they are not round like the old ones. Is there any particular way to install the clutch plates ( line up all the bumps or something else)
Posted Image
Thanks for the help

  • grayracer513

Posted February 01, 2008 - 11:43 PM

#2

My first reaction is that that clutch plate is defective. I would start by returning them.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Nizzle

Posted February 01, 2008 - 11:49 PM

#3

ya i didnt think it looked right but i wasn't sure because all of them look like that

  • SXP

Posted February 02, 2008 - 02:20 PM

#4

I bought my 99 WR400 used in 2003 and it came with the exact same kind of steel plates in the clutch. 7000 miles later they still measure in spec, are still in the bike with nary a sign of fading or slipping.

  • William1

Posted February 02, 2008 - 03:22 PM

#5

Yamaha used plates like that in the past,

The procedure is to install them all off by one notch in the basket. You should end up with them evenly offset in a circle. The idea is the slight imbalance adis in clutch releasing.





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.