2003 wr450f clutch question


3 replies to this topic
  • graazzy

Posted January 10, 2008 - 09:14 PM

#1

When i pulled the clutch plates out to look for notches on the clutch basket fingers,i found two spacer rings that are not mentioned in the workshop manual.They were sitting against the inside face of the basket,one is dish shaped with the words "out side" stamped on it ,The other shaped flat.does anyone no about these, can i leave them out?:banghead:

  • brt 426

Posted January 16, 2008 - 01:12 AM

#2

No need to leave them out.
They are called -clutch damper spring and seat plate. You need to recheck your manual or check the 426 manual for there location. In my 426 manual it shows they are fitted first upon reassembly, before any clutch plates are fitted.
Have fun

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • graazzy

Posted January 17, 2008 - 01:07 AM

#3

thank you i did reassemble them as you said,may be the previous owner has fitted a 426 clutch.

  • SJMC_DON

Posted January 17, 2008 - 12:22 PM

#4

thank you i did reassemble them as you said,may be the previous owner has fitted a 426 clutch.


Yeah, I don't remeber those on my 04' and I had that clutch apart several times:excuseme:




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.