Oversized bars?


2 replies to this topic
  • bleetham

Posted November 09, 2007 - 10:54 AM

#1

I've finally decided to get the Applied Racing 24mm offset triple clamps for my 06 450. My question is about the Pro Taper bars that came stock on the bike. Are these considered a standard sized bar or an oversized bar? I'm also leaning towards the rubber mount. Any suggestions on this are appreciated.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Ga426owner

Posted November 09, 2007 - 11:02 AM

#2

I've finally decided to get the Applied Racing 24mm offset triple clamps for my 06 450. My question is about the Pro Taper bars that came stock on the bike. Are these considered a standard sized bar or an oversized bar? I'm also leaning towards the rubber mount. Any suggestions on this are appreciated.


I went the same route Applied 24s - rubber mt a awesome set up. You want oversized as the stock bars are oversized. I did find the 06 stock bars to be way too low however and swapped to Windham bend Renthal Twinwall

  • bleetham

Posted November 09, 2007 - 11:17 AM

#3

Thanks for the advice, I agree about the low bars. I'm only 5'6" but they are still a little low so I'll probably replace them when I put on the new clamps.





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.