crankcase oil line??????


4 replies to this topic
  • fc501

Posted October 26, 2007 - 08:16 PM

#1

I had my xr600 frame painted and I spent a whole day trying to install the oil line from the crankcase to the bottom frame oil plug with no sucess! The line to the upper oil plug is easy but the lower is a pain.
Any suggestions? If not am going to take the frame with the motor to the Honda dealer torromow.
thanks

  • martinfan30

Posted October 26, 2007 - 10:38 PM

#2

retry it with a fresh mind first thing in the morn. probably will go together no problem.

the most valueable lesson my dad taught me about wrenching (to avoid MURPHY) was to let it set for awhile and come back later with a fresh mind. EVERY time i do this, the problem is solved.:worthy:

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • creeky

Posted October 27, 2007 - 04:54 AM

#3

Persistance will overcome.

  • fc501

Posted October 27, 2007 - 04:59 AM

#4

thanks, Ive try that. Letting it rest and retry. But I just cant seem to get it attached. I gave up and am taking it to the local Honda dealer in the morning. :worthy:
I rather do it myself, though!

  • zrxer

Posted October 27, 2007 - 07:27 AM

#5

Is the line unattached from the engine? If it's not, then remove it. Start the line on the frame first but only finger tight. Then attach it to the engine. Now tighten everything up. You will have to get a new o-ring for the engine end though. Bruce





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.