Ohmin the stator wires before rewrap


No replies to this topic
  • bt08231

Posted October 20, 2007 - 12:59 PM

#1

In testing the stator exciter coil, tested the resistance across the two wires and the resistance was within range, 235. Checked continuity from each wire to the frame and 1 wire showed continuity to ground, and the other one didnt, is this normal. Or should both be isolated??? The coil is replaced so its not that, everything else ohmed out correctly and the manuel says replace the cdi, but if the stator's two wires are both sopposed to show continuity, that would throw things off. Your thoughts.........





Related Content

Forums
Photo
Supercross

Supercross Preview 2017 Part 1: Championship Contenders by Chris Cooksey


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  186 replies
Wiki
Want to add a kickstart to your XR650L?  Here's how - last post by clc3251

Want to add a kickstart to your XR650L? Here's how


Articles
  • 1 reply
Forums
Photo

Wiseco 101MM Spark Knock Low Engine Temps by imandrewparks


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 9 replies
Forums
Photo

ignitech programmable XR650L CDI by brianhare


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  60 replies
Reviews

Honda XR650L 2016 by Chris.GVS


Honda XR650L 2016
  • - - - - -
  • 0 reviews
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.