Need a Dimension. Rear Case bushing on YZ400-450F

1 reply to this topic
  • Groves187

Posted September 30, 2007 - 11:25 AM


I am looking for a dimensions for the case bushing that the pivot bolt runs threw. I dont have any bushing in my motor to measure of off so I figured I would put up a post and see if anyone had a motor out they could measure them from. The only thing I need to know is how much the bushing sticks out on each side of the cases.

Here is a link to a parts finder that shows what i am talking about, They call it a "Collar" The # on the page is 23.


Thanks, Nick

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • grayracer513

Posted September 30, 2007 - 01:38 PM


The thickness of each of the collars is half the difference between the gap between the installed swing arm bearing sleeves and the width of the rear of the case where the collars go.

Related Content


Help with 2000 yz426 by weekend woods racer

Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • Hot  36 replies

First Hare scramble tips by dhend8

Dirt Bike   General Dirt Bike Forums   General Dirt Bike Discussion
  • Hot  33 replies

Is the 2016 GYTR Yamaha YZ450F too fast? by Fryboy

Dirt Bike   Special Interest Forums   Pro Racing
  • * - - - -
  • Hot  241 replies

yz400f throttle bog by yz400fmaniac

Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • * * * * *
  • Hot  28 replies

Michigan Motocross Tires by 288yz450

Dirt Bike   Dirt Bike Regional Discussion   North
  • 1 reply

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.