02 426 with a WB E2


No replies to this topic
  • slammmin72

Posted September 19, 2007 - 08:37 PM

#1

just put it on, and it doesn't seem to want to start like it used to with the older WB E series (the one with the plates) anybody have any suggestions as far as jetting goes? my shop manual says
I ride at Sea Level

main jet 162
pilot jet 42
fuel screw 1 3/8 turns out
4th groove with the stock needle

but my JD Jetting says
main jet 170
blue tipped needle with it in the 4th groove
fuel screw 1 1/4 turns

can someone please point me in the right direction, i loved my E_series pipe, it was a bit loud, but ran great, always started first kick. no popping, awesome power, this new E2 looks great, but the tip (with the spark arrestor) appears to look very restrictive.. (what do i know though)
Thanks!





Related Content

Forums
Photo

James Stewart back on a YZ450F by YamaLink


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  47 replies
Forums
Photo

Should I buy this bike? help....... by Numsa Hul


Dirt Bike   General Dirt Bike Forums   What bike should I buy?
  • * * * * *
  • 10 replies
Forums
Photo

The "going back to the other darkside" adventure... by Monk


Dirt Bike   Make / Model Specific   KTM   250/350/450/505 SX-F & XC-F (4-Strokes)
  • Hot  113 replies
Forums
Photo

1998 yz400f will not idle. by trolley


Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • Hot  32 replies
Reviews

Yamaha YZ450F 2017 by Chris.GVS


Yamaha YZ450F 2017
  • * * * * *
  • 1 review
  • Last review by Tommyk_55
  • On January 15, 2017
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.