time for a valve adjustment


2 replies to this topic
  • saucebox

Posted September 11, 2007 - 03:35 PM

#1

quick question for you guys. checked my valves last night and the exhaust are a little on the tight side. .006" and the intakes were a .003 to a snug .004. this will be my first ever valve adjustment and after going to the stealership they werent able to tell me what shims i need. said i need to see what is in there already. I was wondering what they come with stock? They printed off the chart in the manual at the stealership but that pretty much tells me i need to know what number is in there already. The reason i want to know is because i dont want to make a multiple day project out of this. I'm not always home from work when they close so if i rip it apart to find out what numbers are in there it could be a week before i can make it to the dealer!

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Fastest1

Posted September 11, 2007 - 04:36 PM

#2

You have to look to see what you have! Then you will have to do the math to figure out which shims you need. Easier to buy a Hot Cams shim kit, that way you will have all you need. If I call the stealership here in Houston (any of them), they tell me they dont have any shims. I always wonder how they are in business. 5th largest city in the nation and 2nd largest state in off road cycle sales and no dealership stocks anything. Buy the kit and dont be too intimidated, just take your time. Btw the factory uses shims that wont be available to you. You will see numbers on the shims not on the charts.

  • grayracer513

Posted September 11, 2007 - 08:35 PM

#3

The reason i want to know is because i dont want to make a multiple day project out of this.

You can avoid that only by spending upwards of $100 on a kit full of a whole bunch of shims you will never need.

Your best bet is to start in the morning, determine what shims you need, and go to a shop that sells Hondas. They will more than likely have the shims you need (for a CRF450, 9.48mm diameter), and you'll be able to finish up the same day.





Related Content

Forums
Photo

YZ450F 03 Sparks driving me crazy by SirAttard


Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • 5 replies
Forums
Photo

Snake pit oct 30th by The Anvil


Dirt Bike   Dirt Bike Regional Discussion   California
  • Hot  293 replies
Wiki
WR Camshaft Swap Info - last post by jamesm113

WR Camshaft Swap Info


Articles
  • 0 replies
Forums
Photo

Is it worth it? (Cam and High compression piston) by macgi77


Dirt Bike   Make / Model Specific   Honda   CRF 150/230 F/L
  • Hot  36 replies
Forums
Photo

Megabomb Fitment by 288yz450


Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • 1 reply
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.