Gusseting Pro Circuit header?


No replies to this topic
  • dbehr624

Posted September 02, 2007 - 01:50 PM

#1

Well I recently purchased a new pro circuit header, since i bent two stock ones over nothing falls. My question is, I was thinking of making somewhat of a gusset and tacking it on to the top of the head pipe so it wont bend in the case of similar accidents. What are your opinions. I am sick of bending head pipes but am curious of a stainless steel pipe would be able to withstand a little more abuse. Thanks for any input in advance.

-Darren





Related Content

Forums
Photo

James Stewart back on a YZ450F by YamaLink


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  47 replies
Forums
Photo

YZ450FX OR YZ450F by MESSMAKER


Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • Hot  30 replies
Forums
Photo

The "going back to the other darkside" adventure... by Monk


Dirt Bike   Make / Model Specific   KTM   250/350/450/505 SX-F & XC-F (4-Strokes)
  • Hot  113 replies
Forums
Photo

Megabomb Fitment by 288yz450


Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • 1 reply
Forums
Photo

Should I buy this bike? help....... by Numsa Hul


Dirt Bike   General Dirt Bike Forums   What bike should I buy?
  • * * * * *
  • 10 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.