07 flywheel install


1 reply to this topic
  • frankycottonrow

Posted September 02, 2007 - 08:34 AM

#1

Is it neccesary to disconnect cdi magneto lead, b/c it is a sucker to get the wires apart or can I just pull off the cover and leave it hanging??

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • grayracer513

Posted September 02, 2007 - 09:04 AM

#2

If you're going to do that, hang the cover by one of the bolt holes on a wire hook. Once you figure out the latch, the terminal connectors aren't that difficult to disconnect (except for where some of them were put)





Related Content

Forums
Photo

James Stewart back on a YZ450F by YamaLink


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  47 replies
Forums
Photo

Should I buy this bike? help....... by Numsa Hul


Dirt Bike   General Dirt Bike Forums   What bike should I buy?
  • * * * * *
  • 10 replies
Forums
Photo

YZ450FX OR YZ450F by MESSMAKER


Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • Hot  30 replies
Forums
Photo

The "going back to the other darkside" adventure... by Monk


Dirt Bike   Make / Model Specific   KTM   250/350/450/505 SX-F & XC-F (4-Strokes)
  • Hot  113 replies
Forums
Photo

Is it worth it? (Cam and High compression piston) by macgi77


Dirt Bike   Make / Model Specific   Honda   CRF 150/230 F/L
  • Hot  36 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.