carbon removel

No replies to this topic
  • tom nolan

Posted August 30, 2007 - 10:21 AM


I read a tread on the difficulty of removing carbon from the combustion chamber. Now I can't find the tread again so I'll answer it in a new one. I have had great luck using berryman's B-12. You fill up the combustion chamber and let it soak a few hours and the carbon brushes off with a tooth bursh. I started using this stuff when a aircraft engine manufacture recommended using it on the turbocharge seals to remove the carbon build-up on the seals. The stuff works great. I hope this helps someone out there that was asking.

Related Content


Thinking about Yamaha 250... by Arctic Pride

Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  491 replies

2016 YZ450 by CaptainKnobby

Dirt Bike   Dirt Bike Technical Forums   Suspension
  • Hot  59 replies
WR Camshaft Swap Info - last post by jamesm113

WR Camshaft Swap Info

  • 0 replies

The "going back to the other darkside" adventure... by Monk

Dirt Bike   Make / Model Specific   KTM   250/350/450/505 SX-F & XC-F (4-Strokes)
  • Hot  113 replies

yz250x vs 450 4t comparisons (preferably desert riding) needed by JakeNorthrupYZ450F

Dirt Bike   Make / Model Specific   Yamaha   Yamaha 2-Stroke
  • 9 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.