James D. EKP Needle + Options



2 replies to this topic
  • Clark_Mason

Posted July 28, 2000 - 10:30 AM

#1

James

Is there a needle that starts the taper a little later then the EK* or EM* needle. I would like the get a EPP, ERP or a ESP for experimentation. Now ESP thats got to be the needle I can imagin it doing everthing well.

Clark

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • James_Dean

Posted July 30, 2000 - 10:07 PM

#2

Clark,
Out of the possible combinations only -
EKN, EMN, ---
EKP, EMP, EVP
EKQ, ---, EVQ
EKR, EMR, EVR
There is little point in getting all the combinations because they are only different in the position of where the taper starts or clip position. Moving the clip will give the same result. For example EPP#4 equals ERP#5 equals ETP#6(***if these needles were actually made***). ESP would be at 1/2 clip position between ERP and ETP. This gets to be splitting hairs, but Honda has done this on their CR250's as options for REALLY fine tuning.
The OBEK- and OBEV- are anodized aluminum and are Yamaha needle options for YZ's. The OCEM- and OCEVQ/OCEVR needles are brass and are available from Sudco or Carb Parts Warehouse.
-EMN, EMP, and EMR needles cover the range for most possibilities and allow modification since they are an unplated brass.
James Dean

[This message has been edited by James Dean (edited 07-31-2000).]

  • James_Dean

Posted July 31, 2000 - 08:10 PM

#3

:) :D :D :D Here it is Clark.




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.