Baja Designs Kit with front brake switch?

4 replies to this topic
  • TrailRiderXRL

Posted August 01, 2007 - 06:45 AM


I have a B/D D/S kit and want to wire in a front brake switch. I have the 10mm x 1.25 bango bolt switch but would like any tips on a clean install. Anyone have a diagram on how to do this?



  • cleonard

Posted August 01, 2007 - 07:23 AM


Just wire it in parallel with the rear brake light switch.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • jetfuel

Posted August 01, 2007 - 09:23 AM


Just wire it in parallel with the rear brake light switch.

Exactly ... two wires in heat shrink routed nicely up to the switch tie wrapped in place allowing for bar movement... crimp on two connectors for the switch and splice in the other ends in parallel with the rear wires and your good to go...

  • black in RI

Posted August 01, 2007 - 09:37 AM


yup i did the same thing . it was pretty easy really. Jus tmake sure there are no pinchpoint etc that the wire can get caught or pinched.

  • TrailRiderXRL

Posted August 01, 2007 - 11:01 AM


Thanks guys for the help! All done and it turned out great!

Related Content


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.