sag



1 reply to this topic
  • Kyle

Posted May 21, 2000 - 09:26 PM

#1

I just measured the rear sag per the manual and the difference is 5 inches not the recommended 3.5 to 4. I weigh 185 with full gear.
Question is, to decrease this difference would I loosen the adjuster to decrease pressure on the spring? Also any idea where to find a tape measure in mm. instead of inches?

Dougie I will be following your progress on here with the suspension deal, I too am getting interested in this.

Thanks all,

Kyle

------------------
'00 WR, Renthal bars, Cycra hand guards, throttle stop cut,for now everything else stock

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Kevin_in_New_Hampshire

Posted May 21, 2000 - 10:03 AM

#2

You want to turn the collar to push up against the spring, NOT away from the spring. That would be counter-clockwise if viewed from above.
To convert inches to metric, there are 2.54cm (25.4mm)per inch. Multiply your inches by 25.4(mm) to get your answer.


[This message has been edited by Kevin in New Hampshire (edited 05-21-2000).]




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.