Moab



2 replies to this topic
  • Guest_Guest_*

Posted October 24, 2000 - 02:43 AM

#1

I'm going to Moab tomorrow and want to make sure I have my bike jetted correctly. :)
For the guys that went to Moab a few weeks ago do you have any suggestions? I have a 98 WR that is totally stock. Right now it is jetted for Denver. Help!! :confused

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Dougie

Posted October 24, 2000 - 08:05 AM

#2

You may need to go up one size on your main and possibly a 1/4 out on the fuel screw. That is if you bike is running great right now. Or you may need to do nothing.

Mine is YZ timed and I ran the same jetting in Moab that I do in Denver. No problems at all. In fact, it probably ran better than here. Moab is around 4000 - 5000 ft.

------------------
Dougie, '99 WR400 with a lot of dumb, stupid, here take my money, I have to have them but they don't make me a better rider extra mods.
(Except the dampner :))

  • RayG

Posted October 24, 2000 - 08:08 AM

#3

Thanks Dougie,

Normally when I go to Moab my bike has ran awesome. However I had it jetted to a little higher elevation so I was worried what the effect would be. I think I will just wait and see what happens. Thanks Again...




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.