Front Hub MN1-FR, Bearing Swap?????

1 reply to this topic
  • letsrideinsc

Posted June 21, 2007 - 09:13 PM


I have a 92xr600r, It has a cartridge system fork on it, but a smaller axle. I have just acquired a set of excel rims with the stock black hubs, from what year? not sure. The Excel front wheel is missing the axle but the bearings and internal axle sleeve remain. My stock axle is smaller in dia. by a mm or 2. I'm thinking I swap the bearings to the old diameter and I'm golden. Am I correct? This is the same hub shell, so I can use my 91 fork with the small axle with a set of 98 hubs(by changing out the bearings)

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Firelyle

Posted June 22, 2007 - 08:42 AM


As long as the bearings match both the hubs and axle (diameter wise) you'll be just fine. Any bearing shop will have what you need.
Good Luck :thumbsup:

Related Content


Can anyone identify this xr600 piston? by ms_mtn24

Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 4 replies

What was your path to Beta? by officialhopsof

Dirt Bike   Make / Model Specific   Beta
  • Hot  79 replies

1993 XR600R rebuild by ove

Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  41 replies

Fell Off Trailer by usafxr

Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  43 replies

Which thumper motor for a street tracker? by woz

Dirt Bike   General Dirt Bike Forums   General Dirt Bike Discussion
  • * * * * -
  • Hot  29 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.