New handlebar issue..worth a read..


2 replies to this topic
  • wickedsprint

Posted June 11, 2007 - 08:52 AM

#1

So after installing new bars on my 650, the engine would quit if you turned the bars to the right, spent a good 20 minutes trying to figure it out thinking electrical short somewhere, disconnected GPS/Headlight Kill switch, turns out I did not put the clutch handle where it needed to be on the bar, had it about an inch or two too far out, and when turning the bars to the right it was pulling on my decomp cable. Nice.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • martinfan30

Posted June 11, 2007 - 10:43 AM

#2

ATTA BOY!!!:thumbsup:

  • Firelyle

Posted June 11, 2007 - 12:28 PM

#3

:thumbsup: Glad to know I'm not the only one who does stupid things from time to time!!





Related Content

Forums
Photo

Engine Loping/Sputtering by tcaldwell


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 2 replies
Forums
Photo

XR650L super moto wheels by greggkklee


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  28 replies
Forums
Photo

93 xr650l Restoration Project by Zigster


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 17 replies
Forums
Photo

Which thumper motor for a street tracker? by woz


Dirt Bike   General Dirt Bike Forums   General Dirt Bike Discussion
  • * * * * -
  • Hot  29 replies
Reviews

Honda XR650L 2016 by Chris.GVS


Honda XR650L 2016
  • - - - - -
  • 0 reviews
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.