Question about installing Clutch Boss/Drive Gear assembly without clutch tool


3 replies to this topic
  • gerbrony450

Posted May 15, 2007 - 12:09 PM

#1

I am in the process of replacing the primary drive and clutch assembly. any recommendations on getting the main clutch nutt torqued without using a clutch tool? I was able to get it off with an impact initially, but dont want to put it back on that way. Thanks

  • 642MX

Posted May 15, 2007 - 01:54 PM

#2

You can install all the metals and fibers and then take your hand and push in on the last fiber plate to keep it from spinning.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • yz4fun

Posted May 15, 2007 - 06:20 PM

#3

be safe and get a clutch tool.

  • grayracer513

Posted May 15, 2007 - 07:09 PM

#4

Put the bike in a high gear and place a board through the spokes across the swing arm to lock the transmission. Then you can torque it up in peace.





Related Content

Forums
Photo

BIGBORE FOR YZ450F 2006? by Taattie94


Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • 5 replies
Forums
Photo

Is it worth it? (Cam and High compression piston) by macgi77


Dirt Bike   Make / Model Specific   Honda   CRF 150/230 F/L
  • Hot  36 replies
Forums
Photo

05 yz450f not fast enough by RedeyeYZ


Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • Hot  38 replies
Forums
Photo

Snake pit oct 30th by The Anvil


Dirt Bike   Dirt Bike Regional Discussion   California
  • Hot  293 replies
Forums
Photo

Should I buy this bike? help....... by Numsa Hul


Dirt Bike   General Dirt Bike Forums   What bike should I buy?
  • * * * * *
  • 10 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.