Rear Brake issues


4 replies to this topic
  • billybob20

Posted May 04, 2007 - 09:03 PM

#1

I just recently replaced my rear brake on my 06' YZ450. But, I cannot get my brake to work. I've blead the brakes many times and can still not get the piston inside the caliper to push up against the brake bads. There is not pressure what so ever. The brake pedal has to resistance when I pump it. I've added brake fluid probably 5 different times because I've blead them so much. Do you have any suggestions?

  • 02YZ426

Posted May 05, 2007 - 05:48 AM

#2

Did the piston work ok before you replaced the brakes?

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • grayracer513

Posted May 05, 2007 - 08:03 AM

#3

You probably have an air bubble trapped at the line fitting at the master cylinder. Bleed the air from there, then try bleeding the whole line again.

  • Racer24

Posted May 05, 2007 - 01:26 PM

#4

i suggest bleeding it again and or checking to see if there is any seal damage, if there is then that could be the reason why there no resistance and no pressure on the disk

  • grayracer513

Posted May 05, 2007 - 02:04 PM

#5

You can bleed it continuously for the next week if you like, but if there's a bubble at the MC output port and banjo fitting, which is the high spot in the system, all you'll be doing is pumping fluid around and under it, and it will just stay right there. Been there.





Related Content

Forums
Photo

First Hare scramble tips by dhend8


Dirt Bike   General Dirt Bike Forums   General Dirt Bike Discussion
  • Hot  33 replies
Forums
Photo
Motocross

Thinking about Yamaha 250... by Arctic Pride


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  491 replies
Forums
Photo

yz250x vs 450 4t comparisons (preferably desert riding) needed by JakeNorthrupYZ450F


Dirt Bike   Make / Model Specific   Yamaha   Yamaha 2-Stroke
  • 9 replies
Forums
Photo

Michigan Motocross Tires by 288yz450


Dirt Bike   Dirt Bike Regional Discussion   North
  • 1 reply
Forums
Photo

Is it worth it? (Cam and High compression piston) by macgi77


Dirt Bike   Make / Model Specific   Honda   CRF 150/230 F/L
  • Hot  36 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.