Cycra Probend Handguards


2 replies to this topic
  • Twig323

Posted April 19, 2007 - 08:29 AM

#1

Has anyone mounted these to an 07 450F I purchased the tripple clamp mounts and they come no where near the correct place. I emailed them and said I should have no problem with the side mount application.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • NorCal

Posted April 19, 2007 - 08:39 AM

#2

Has anyone mounted these to an 07 450F I purchased the tripple clamp mounts and they come no where near the correct place. I emailed them and said I should have no problem with the side mount application.



I ran into the same problem. The original bar mounts that come with the probends worked out just fine, so I took the tripple clamp mounts back. Otherwise, you will have to heat and bend your handgaurds until they fit.

  • Stripes123

Posted April 19, 2007 - 12:40 PM

#3

I went with the U-clamp mount

http://i41.photobuck...SCN02570022.jpg





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.