426F Carburetor question


1 reply to this topic
  • asdfasdfffewg

Posted April 14, 2007 - 10:56 AM

#1

I bought a new needle valve but I dont know if I should replace the housing and screen that came along with it. I wanted to go ahead and do it but I dont know how the old housing comes out. I don't have an owners manual or anything either. Can't wait to start riding again... Thanks for any suggestions.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • grayracer513

Posted April 14, 2007 - 03:24 PM

#2

Looking straight at the underside of the float camber, there is a screw and washer immediately next to the float needle seat. This screw holds the seat into the carb body. Replace both the needle and the seat.

For a manual, look at the bottom of the page in the Common Threads Sticky, top of the forum index.





Related Content

Forums
Photo

Snake pit oct 30th by The Anvil


Dirt Bike   Dirt Bike Regional Discussion   California
  • Hot  293 replies
Forums
Photo

yz250x vs 450 4t comparisons (preferably desert riding) needed by JakeNorthrupYZ450F


Dirt Bike   Make / Model Specific   Yamaha   Yamaha 2-Stroke
  • 9 replies
Forums
Photo

2016 YZ450 by CaptainKnobby


Dirt Bike   Dirt Bike Technical Forums   Suspension
  • Hot  59 replies
Forums
Photo

Should I buy this bike? help....... by Numsa Hul


Dirt Bike   General Dirt Bike Forums   What bike should I buy?
  • * * * * *
  • 10 replies
Forums
Photo
Motocross

Thinking about Yamaha 250... by Arctic Pride


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  491 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.