Wire removal


2 replies to this topic
  • MaxPower

Posted April 02, 2007 - 12:37 AM

#1

[COLOR="Green"]You know that funky little wire that runs from the clutch perch?
I want to remove it. do I cut them short and tie the together or tape them off seperatly? Thanks[/COLOR]

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • jim-in-so-ore

Posted April 02, 2007 - 05:40 AM

#2

Loop them back together and solder them, then use shrink tubing. If you do this you can still use the electic start as it was intended but if you don't pull in the clutch the starter will move the bike while in gear.:bonk:
Jim

  • AnimalDan

Posted April 02, 2007 - 10:02 AM

#3

Or just pull the little switch out of the clutch perch and tape it back on the wire harness. This will also work like Jim says.




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.