07 WR450 TT AIS removal kit - tip

1 reply to this topic
  • Jammer

Posted March 31, 2007 - 11:47 AM


Just installed the TT AIS removal kit. The OE fitting at the front of the head, held on by 2 screws, is difficult to get at the 1 screw due to the rad pipe & hose getting in the way. I used an allen key with a "ball" end on it - so you can turn allen head screws with the wrench on an angle. Worked perfectly and I didn't need to drain the coolant, remove the hose, etc.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • WR_Dave

Posted March 31, 2007 - 12:22 PM


Also when using the ball end allen wrench loosen the hard to get at bolt first and take it out before the easy one and then reverse the procedure for reassembly. WR Dave.


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.