Dual filament bulb question xr650r


No replies to this topic
  • wickedsprint

Posted March 21, 2007 - 07:53 PM

#1

Noticed the glass lens and assembly off the XR600 from the early 90s is a bolt in to the stock shroud, however being an H3, which appears to have a lead for the high and low beam, and my stock wiring is setup to run only one beam, can I just tie in the high as well and run both circuits off the main power lead? Don't really feel like wiring in a hi/lo beam switch.





Related Content

Forums
Photo

ignitech programmable XR650L CDI by brianhare


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  60 replies
Forums
Photo

Post Apocalypse, ThumperTalk style! by Justin Pearson


Dirt Bike   General Dirt Bike Forums   General Dirt Bike Discussion
  • Hot  35 replies
Forums
Photo

Wiseco 101MM Spark Knock Low Engine Temps by imandrewparks


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 9 replies
Forums
Photo

93 xr650l Restoration Project by Zigster


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 17 replies
Forums
Photo

XR650L super moto wheels by greggkklee


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  29 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.