L.E.D blinkers with led flashing indicator lite

1 reply to this topic
  • drtlvr

Posted February 18, 2007 - 06:38 PM


well I just finished hooking up my flashing led blinker indicator lite, the trick is to 1# split the positive wire off the led so you have two wires instead of one.
2# solder a diode on each of these wires so that the power can only feed toward the led.
3# now take your right blinker wire,the one that comes from your blinker and hook that wire to the other end of the diode and then to the sky blue wire.
4# now take your left blinker wire the one that comes from your blinker and hook it up to the other diode then hook it into the orange wire.
5# hook all the grounds together.
6# your blinkers should now work the led indicator.

this set up works if you already have led blinkers with the correct flasher.
you can get the diodes at radio shack,not sure of the part number,but just ask them for them and tell them there for 12 volt.

good luck:thumbsup:

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • hypersthenos

Posted February 18, 2007 - 07:45 PM


Cool. Thanks for the info. I find my blinkers on all too often without an indicator. Sounds like a simple upgrade.

Related Content


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.