YZ426 to 450 Cylinder swap

2 replies to this topic
  • BuckHopkins

Posted February 10, 2007 - 06:06 PM


Has anyone sucessfully swapped a 450 cylinder into a 426? i have a 426 that i love but would like more power out of it! (i'm getting fat in my old age)

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Pincushion

Posted February 10, 2007 - 06:39 PM


Punch the stock jug to accept a 97mm piston and you'll have a 444. Much easier than grafting a 450 jug to a 426 lower end. Dont expect miracles though.... your 426 isn't too far off the 450's as it sits stock.

  • j753301

Posted February 10, 2007 - 11:14 PM


the difference between the 2 is the stroke not the bore.the 426 and the 450 have the same 95mm bore so putting the 450(63.4mm stroke) on the 426 (60.1mm stroke) will do nothing.

Related Content


Thinking about Yamaha 250... by Arctic Pride

Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  491 replies

Chubby dad, looking at bikes , First trip to the orange/black forum ! by Slow_ride

Dirt Bike   Make / Model Specific   KTM   250-530 EXC/MXC/SXC/XC-W/XCR-W (4-Strokes)
  • Hot  28 replies

100 hrs on 2014 yz450f, shim valves or replace them? by ttr230rider6

Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • Hot  79 replies

Snake pit oct 30th by The Anvil

Dirt Bike   Dirt Bike Regional Discussion   California
  • Hot  106 replies

2016 YZ450 by CaptainKnobby

Dirt Bike   Dirt Bike Technical Forums   Suspension
  • Hot  59 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.