Information needed. Clutch plates


2 replies to this topic
  • Devil

Posted February 02, 2007 - 05:36 PM

#1

I have an XR600 clutch that I have purchased second hand for my '94 XR600. The clutch plates have 3 machined half circular indents evenly spaced on the drive tangs. Question: do these indicate the orientation of each plate or do you just stack them into the basket in any order.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • bork

Posted February 05, 2007 - 06:32 AM

#2

I haven't gone in yet but I do need to do a clutch job too. So I hope to find this out before also. Even though I cant picture what your talking about, but I'm sure someone does.

  • EddieTNT

Posted February 24, 2007 - 03:44 PM

#3

My R has them too. I just stack 'em in a button it back up. I've never had an issue other than a worn out clutch after about 10,000 miles.





Related Content

Forums
Photo

Wiseco 101MM Spark Knock Low Engine Temps by imandrewparks


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 9 replies
Forums
Photo

Fell Off Trailer by usafxr


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  43 replies
Forums
Photo

XR650L super moto wheels by greggkklee


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  29 replies
Forums
Photo

DirttyPig 2005 Xr650l Prroject! by braapmebb1moretime


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 22 replies
Forums
Photo

93 xr650l Restoration Project by Zigster


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 17 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.