Wheel bearing removal tool

2 replies to this topic
  • jetfuel

Posted January 28, 2007 - 07:52 AM


I shared this info on the XR forum so I thought I'd share it here too.. Use a 3/8" drive extension (6 inch at least) grind the end that attaches to the ratchet slightly as to remove the rounded edge and make it flat and sharp. insert that end into wheel and drive away...it has a better surface area than any screw driver or chisel that I've seen other people use ...I've used this tool way back on my 89' CR500 and every bike since..hope it helps

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Beejay

Posted January 28, 2007 - 03:59 PM


Just buy/use a wide flat face punch thats what they're made for.

  • Indy_WR450

Posted January 28, 2007 - 06:02 PM


Big flat screw driver works just fine everytime.:ride:


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.