07 WR450 AIS Removal


1 reply to this topic
  • epicracing

Posted January 18, 2007 - 09:59 PM

#1

I recently bought a 07 WR450. I bought the GYTR AIS removal kit for 06 since the 07 kit isn't out yet. It does not seem like it will fit where the stainless tube is removed from the head. I already replaced the throttle stop screw, put in the new pilot jet, new needle, and now the bike falls on its face unless you role on the throttle. Does the leak jet and main jet need replaced? Any suggestions would be greatly appreciated. Getting to the carb sucks and I only want to do it one more time.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Murray Dorward

Posted January 19, 2007 - 03:47 AM

#2

Remember to do the airfilter, grey wire and remove the restictor from the exhaust.

As far as the carb goes: You only have to change the pilot jet and the needle jet (set your clip on 4th from the top )and Remember to set your airscrew two full turns out.

Cheers

Muz
:lol: :crazy: :confused:




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.