Adding oil to Forks?



3 replies to this topic
  • rep

Posted January 04, 2002 - 07:48 PM

#1

Any easy way to add oil to forks besides pulling out of triple clamps and removing caps? Forgot to look to see if the bleed screw in the cap provides a direct passage big enogh to add oil through.

I set mine at the factory level of 135mm and worried it may be too soft for my bad to the bone 140 lbs.

thanks

rep

  • skthom2320

Posted January 05, 2002 - 06:56 AM

#2

You can add it through the bleed screw. 14cc is about 10mm in oil height.

Regards,

Steve T

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • rep

Posted January 05, 2002 - 08:51 PM

#3

thanks man!

  • yzernie

Posted January 06, 2002 - 07:46 PM

#4

I remove my handlebars, loosen the top clamp bolts and pull the caps. I have tried to put oil in via small bleed hole and it just takes forever. Ten minutes and I'm back on the track.

Ernie




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.