XR650R Fork/disk cover --- XR400


No replies to this topic
  • BWB63

Posted January 03, 2007 - 02:26 PM

#1

You thread the front axle with a 8mm 1.25 tap. Taps real easy. I just tap it while it is in the bike. Drill a hole in the disk cover right below the hole already there. The hole already there might work for some. Use a bolt that is for the right side seat. The one that holds on the side cover and bolts the seat down. I use a aluminum spacer that is 10mm thick, 10mm hole and 25mm outside diameter. That goes between the disk cover and the axle. Put the disk cover on and slide it so the fork fits in the hole in the bottom. line up the hole with the axle bolt hole that you threaded. Put the spacer behind and line it up. Put the bolt in and tight in up. Put a ty-wrap on the top, where the disk cover is a fork guard. XR400R 96-04 BLACK DISC/FORK COVER By: ACERBIS, $34.95





Related Content

Forums
Photo
Supercross

Supercross Preview 2017 Part 1: Championship Contenders by Chris Cooksey


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  148 replies
Forums
Photo

DirttyPig 2005 Xr650l Prroject! by braapmebb1moretime


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 22 replies
Forums
Photo

Fell Off Trailer by usafxr


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  43 replies
Forums
Photo

XR650L super moto wheels by greggkklee


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  28 replies
Forums
Photo

Engine Loping/Sputtering by tcaldwell


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 2 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.