feeler gauge


2 replies to this topic
  • Blank Stare

Posted December 15, 2006 - 09:38 AM

#1

The feeler gauges i have are to wide to check all of the valves. Where can i get a thinner one? I am only able to check 3 of the 5 valves on my 450.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Bigcr

Posted December 15, 2006 - 10:36 AM

#2

You can either get the individual units from Motion Pro or get a cheap set and cut them lengthwise(that's what I did).

  • grayracer513

Posted December 15, 2006 - 01:31 PM

#3

I have no problem using the standard 4" feelers in my YZ450's, or any of the several 426's I've checked.

However, if yours are too wide, simply take a sharp pair of scissors not made in China and trim a little off each side of the few blades you need to do the check with. That's what we did for the 250F center intakes.





Related Content

Forums
Photo
Supercross

Wilson the Blue Privateer by jetfuel


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  50 replies
Wiki
WR Camshaft Swap Info - last post by jamesm113

WR Camshaft Swap Info


Articles
  • 0 replies
Forums
Photo

Chubby dad, looking at bikes , First trip to the orange/black forum ! by Slow_ride


Dirt Bike   Make / Model Specific   KTM   250-530 EXC/MXC/SXC/XC-W/XCR-W (4-Strokes)
  • Hot  28 replies
Reviews

Yamaha YZ450F 2017 by Chris.GVS


Yamaha YZ450F 2017
  • * * * * *
  • 1 review
  • Last review by Tommyk_55
  • On January 15, 2017
Forums
Photo

2016 YZ450 by CaptainKnobby


Dirt Bike   Dirt Bike Technical Forums   Suspension
  • Hot  59 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.