Elec Starter Wiring Diagram ?


2 replies to this topic
  • tvrjohn

Posted December 12, 2006 - 04:39 PM

#1

Hi guys
Having some trouble with WR450 04
When i push the ignition switch in, starter motor turns !
Have disconnected starter button, makes no difference
Had to pull a fuse in starter relay so i could run the engine via kick starter

Changed relay unit next to battery and it makes no difference
Can't see any wires damaged / touching / shorting out

Wiring diagram in online manual here has no colour coding
think this would help, if info is avaliable

Any suggestions,
Help please

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Asgeir

Posted December 13, 2006 - 11:28 AM

#2

I think this applies to the WR450F

Electrical diagram of a WR250F :

http://s26.photobuck...sgeir1965/Tech/

There is this diode that you should check #5

There seem to be 2 relays one # 9 and one close to the starter #12

If removing the relay stops the continius starting and it is not the start button then probably it is a wire that is Blue/Black is shorted to ground.

I can e-mail you better drawings if you PM me your e-mail address.

  • tvrjohn

Posted December 14, 2006 - 02:37 AM

#3

Hi
thanks for that info, however i have sent you a PM for clearer info
Thanks, John




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.