help with coil wire


1 reply to this topic
  • chpxr

Posted November 24, 2006 - 08:24 PM

#1

my question is can the plug wire be removed from the coil and be replaced with a new wire like a taylor 8mm wire i will be removing the resistor in the plug wire to. also if it can how do you remove the plug wire from the coil and is there any tricks to reinstalling it
my bike is a 97 xr600r
thank you
rob

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • timothypg

Posted November 25, 2006 - 06:49 AM

#2

Hi. i took mine out and replaced it w/ some heavy gauge wire i got at the hardware store, cut resistence by a couple ohms. the prob i had was the boot on the coil. it was glued and had to ruin it to get it off. i put the new wire in then ran some heat shrink over the wire and coil to make a new boot. no problems so far. ps. i did this after running down a weak spark issue. after testing every single thing i could i took it apart and bingo, it was the wire.





Related Content

Forums
Photo

Fell Off Trailer by usafxr


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  43 replies
Forums
Photo

2015 XR650L Squeaking noise by Crayjay


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 3 replies
Forums
Photo

93 xr650l Restoration Project by Zigster


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 17 replies
Reviews

Honda XR650L 2016 by Chris.GVS


Honda XR650L 2016
  • - - - - -
  • 0 reviews
Forums
Photo

Engine Loping/Sputtering by tcaldwell


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 2 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.