carburetor problems

3 replies to this topic
  • izzywr

Posted October 21, 2006 - 09:06 AM


Hi all,
i have replaced a broken valve, needle. since then sometimes the engine is "stuck" in high rpm.
could the reason be that i installed the seal the wrong way?:thumbsdn:
any other suggestions?
thanks. :devil:

  • bandit99

Posted October 21, 2006 - 10:20 AM


It sounds like a sticky throttle. Check the linkage and your cables. Maybe it is getting hung up on something. I would check the choke linkage too.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • izzywr

Posted October 22, 2006 - 06:14 AM


Thanks for the reply.
checked again. dont think that's the issue. the throttle cable is new and the linkage seems fine.
what do u think of the seal issue? does it have a direction?

  • GCannon

Posted October 23, 2006 - 08:56 AM


What Year is your Bike? did you check the Throttle slde for hair line cracks.
You should search for this there are lots of info including pictures on this issue.


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.