Replacing clutch arm seal XR600R

1 reply to this topic
  • Terez

Posted October 18, 2006 - 12:47 AM


Need to replace the clutch arm seal on my 90 XR600R
I guess I will replace the seal and bearing while it's out?

Can I just pull the arm out of the case or do I have to remove the side case?

Any helpful advice/tips as I haven't done this before.


PS Is the extended clutch arm worthwhile in reducing clutch pull?
Seems a good time to do it if I am.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • simon@vic

Posted October 18, 2006 - 06:53 AM


to change the seal on MOST bikes {dont know about the 600} all you need to do is:

-detach the cable
-spin the whole arm and shaft 1/2 a turn
-pull it up and out
-pop out the seal

if you want to do the bearing you will have to remove the cover.

Related Content


93 xr650l Restoration Project by Zigster

Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 17 replies

Fell Off Trailer by usafxr

Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  43 replies

Can anyone identify this xr600 piston? by ms_mtn24

Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 4 replies

Post Apocalypse, ThumperTalk style! by Justin Pearson

Dirt Bike   General Dirt Bike Forums   General Dirt Bike Discussion
  • Hot  35 replies

Cle Elum Sunday 5/29: Looking for dual sport tips by TigerTanker

Dirt Bike   Dirt Bike Regional Discussion   Northwest
  • Hot  32 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.