650L head gasket for a big bore 600?

2 replies to this topic
  • rg_series

Posted September 24, 2006 - 03:07 PM


would it be okay to use a 100mm 650L head gasket in a 100.5 mm bore xr600? Honda might have an oversize gasket, but other than size are the two gaskets alike? Thank in advance.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • cleonard

Posted September 25, 2006 - 11:35 AM


I'm not sure. I know that the XL600 has a 100mm bore and those will work. A call to XRsonly should answer your question. They sell XR600 gasket kits for 98,100,101, and 102 mm pistons.

  • rebelventurer

Posted September 25, 2006 - 02:47 PM


Call Kamell at www.albakersxrsonly.com ph.#760-244-2626 he will give you the right info. Don't play around guessing or taking anyones advise that is guessing, you blow up your spending big bucks. I do reccomend using Cometic gaskets for the xr600, Good Luck!!!!

Related Content


Engine Loping/Sputtering by tcaldwell

Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 2 replies

Which thumper motor for a street tracker? by woz

Dirt Bike   General Dirt Bike Forums   General Dirt Bike Discussion
  • * * * * -
  • Hot  29 replies

Fell Off Trailer by usafxr

Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  43 replies

2015 XR650L Squeaking noise by Crayjay

Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 3 replies

ignitech programmable XR650L CDI by brianhare

Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  60 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.