Engine Installation


2 replies to this topic
  • sparkyz

Posted September 14, 2006 - 08:53 PM

#1

I'm hoping to get my engine back together tomorrow and was kinda going over my whole procedure but wasn't sure if I would be ok to completely assemble the engine and then put it back into the frame due to any clearance issues. When disassembling I removed the engine from the frame after removing the cylinder. I was thinking it may be easier to put it all together on the bench but not sure if it will fit in easily fully assembled. Thanks for any input.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • John407

Posted September 14, 2006 - 09:06 PM

#2

I put mine in without the shifter on but that's it. It might be a little tight but that's the way to do it. Of course you already have the rads, gastank etc. off.

  • sparkyz

Posted September 14, 2006 - 09:10 PM

#3

Thanks for the quick reply, now all I need is for my crankshaft to show up tomorrow and I'll be set.





Related Content

Forums
Photo

Should I buy this bike? help....... by Numsa Hul


Dirt Bike   General Dirt Bike Forums   What bike should I buy?
  • * * * * *
  • 10 replies
Forums
Photo
Supercross

Wilson the Blue Privateer by jetfuel


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  50 replies
Forums
Photo

James Stewart back on a YZ450F by YamaLink


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  47 replies
Forums
Photo

05 yz450f not fast enough by RedeyeYZ


Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • Hot  38 replies
Forums
Photo

The "going back to the other darkside" adventure... by Monk


Dirt Bike   Make / Model Specific   KTM   250/350/450/505 SX-F & XC-F (4-Strokes)
  • Hot  113 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.