JB weld to stop seeping oil leak ?


2 replies to this topic
  • ponq

Posted August 17, 2006 - 08:19 AM

#1

After the 680 project there is a leak between the cases. I guess there wasn't a good seal on the underside of the motor.

I've cleaned it and it appears to be about 4 inches long.

Do you guys think I'll have any issues if I drain the oil. Take a fingertip and run JB weld down the area of the leak?

Or should I just use a gasket maker compound?

Any tips or advise are appreciated.

Thanks

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • sweetk30

Posted August 17, 2006 - 11:45 AM

#2

jb weld is not made to expand and contract like the aluminum in your case. i would drain and brake clean off any contaminents then get some good rtv and apply thay like you wanted to do before. then let it cure fully and refill and see what you get.

  • ponq

Posted August 17, 2006 - 12:50 PM

#3

Thanks, I was thinking I should try that first, but I've done so many things with JB Weld, I though I'd try another.





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.