Install/Remove Clutch Push Lever Bearing


1 reply to this topic
  • JJHayesIII

Posted July 31, 2006 - 09:48 PM

#1

Are there any tricks to doing this? Is this one of those parts that really shouldn't ever get replaced? I can't think of any way to pull that bearing, as a regular blind hole bearing puller won't fit in there...I've checked the factory service manual, and the Clymer's manual, and neither were very helpful...

:thumbsup:

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • JJHayesIII

Posted August 02, 2006 - 12:00 PM

#2

bump...no one's ever bought new cases?




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.