EBC Dirt Racer Clutch - WR450F 2004

No replies to this topic
  • robby250

Posted June 10, 2006 - 01:16 AM


Put a new EBC clutch kit (frcition plates, steels and springs) in my WR450 04, soaked them in oil for 24 hours first. On the first ride out all seemed OK but once the going got sticky and the clutch use increased the clutch would not disengage even with the lever to the bars. Once the clutch use reduced on the quick sections had to adjust back as too tight. Spent all day adjusting at ther lever to compensate.
Has anyone experienced similar?
Any remedies?
Did I do something wrong?
One friction plate in the kit has a larger diameter (friction material about half as wide as the others) I put this one in last.


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.