yz 426 beak locking up/ overheating


2 replies to this topic
  • pontala

Posted June 04, 2006 - 11:37 AM

#1

I being having problem with my rear break, its get overheated and it will lock, I put the caliper apart clean it and put fresh oil but the problem come back again any one can give me some ideas? Maybe the master cylinder is the problem?

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • hedpi

Posted June 04, 2006 - 05:06 PM

#2

it happened to me once on the front because i tuned it too tight, then i gave a bit of slack to the lever and problem gone, maybe your problem is related (lever tight, pads rubbing, disc bent)

  • lightestYZF

Posted June 10, 2006 - 05:53 PM

#3

yes what hedpi said - make sure brake pedal returning all the way (must let master cylinder pin return all the way) and if that not the problem then its probably corrosion on the pins causing slight hanging with resultant heat. Also new pads are thicker than old worn ones and that helps too.





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.