Rear Master Cylinder Problem

No replies to this topic
  • chrisn6104

Posted May 23, 2006 - 08:06 PM


I got the rebuild kit. Replaced all the parts and it still doesn't work. Before I put it on the bike I fill it with fluid and move the piston up and down. I get intermittent fluid out the top where the line screws into. If I have the piston out and fill the reservoir the fluid comes out thru a hole in the cylinder like it's supposed to.
What gives? I know fluid needs to be above the seal where the spring is ... but it's not getting there.
Any ideas?

Related Content


First Hare scramble tips by dhend8

Dirt Bike   General Dirt Bike Forums   General Dirt Bike Discussion
  • Hot  33 replies

yz250x vs 450 4t comparisons (preferably desert riding) needed by JakeNorthrupYZ450F

Dirt Bike   Make / Model Specific   Yamaha   Yamaha 2-Stroke
  • 9 replies

Snake pit oct 30th by The Anvil

Dirt Bike   Dirt Bike Regional Discussion   California
  • Hot  35 replies

2016 YZ450 by CaptainKnobby

Dirt Bike   Dirt Bike Technical Forums   Suspension
  • Hot  59 replies

100 hrs on 2014 yz450f, shim valves or replace them? by ttr230rider6

Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • Hot  79 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.