Rekluse question number 2 (with pics this time)


4 replies to this topic
  • gregwr450f

Posted April 16, 2006 - 09:53 PM

#1

Posted Image
This is the lower assembly, my question is how much sideways movement should there be of the smaller/upper spindle, the one with the red line, the lower (blackline) spindle is held still,
I know it has spin freely, but it does have a lot of sideways movement.
Notice the snapped bolts in the thread holes. :thumbsup:

  • LUKASS

Posted April 16, 2006 - 11:09 PM

#2

Is the tension setting your using correct old lad.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • gregwr450f

Posted April 16, 2006 - 11:12 PM

#3

I'm certain of it :thumbsup:

Back to the sideways movement.

  • Indy_WR450

Posted April 17, 2006 - 05:29 AM

#4

There should be a lot of radial slop in the spindle. That is normal for their design. :thumbsup: Dont forget that the spindle bolts to the inner basket and the outer pressure plates fits snugly into the outer basket. The factory clearance is designed for no radial contact between the parts.

  • gregwr450f

Posted April 18, 2006 - 12:53 AM

#5

Thanks Indy, you a credit to the site!!




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.