Slide Height??


No replies to this topic
  • Sparky_So_Cal

Posted April 06, 2006 - 08:58 PM

#1

I have an 05 yzf450 and have the occasional hanging idle. Like others tried to jet it away, but to no avail. After searching and finding some info on slide height, I measured mine and it was a bit more open. The manual says 1.2mm or .051". I can get a 3/64 bit through there which is .078". The only place the manual talks about slide height is for the AP timer adjustment, which does nothing for the slide height.

Should I use the idle adjustment to obtain the correct slide height and then do AP timer based on the new slide height? Or am I missing something else.

Thanks in advance





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.