What should I put inside?


2 replies to this topic
  • MTRSPORTDAN

Posted March 24, 2006 - 05:08 PM

#1

I cracked the case on my 03 wr450, so I have to pull the whole motor apart to replace it. I get all my Yamaha parts at dealer cost so I am trying to figure out all the parts I need to freshen it up. Since I am in there what bearings do I need? Someone told me that some of the bearings are pressed in and they won't come out clean from the old case. Also since I am in there is there anything else I should do? Any help is appreciated. Thanks, Dan

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Matty05

Posted March 25, 2006 - 05:51 PM

#2

You are better off asking an engine builder, or if you trust your dealership.

  • rockieman

Posted March 25, 2006 - 07:36 PM

#3

I just rebuilt my motor.... a little heat and the (crank) bearings will pop right out.




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.